Clients ask it on almost every job: “Should we do engineered or solid?” The honest answer is that each one has a job, and putting the wrong one down is an expensive way to find out. Here’s how to decide, based on the subfloor and the room, not the sales pitch.
What actually makes them different
Solid hardwood is one piece of real wood from the face to the tongue, 3/4″ thick. Engineered hardwood is a real oak wear layer on top of a stack of plies, each ply turned 90° to the next. That cross-ply core is what keeps an engineered board flat when the humidity can’t make up its mind.

| Solid hardwood | Engineered hardwood | |
|---|---|---|
| Construction | One piece of wood, 3/4″ thick | Oak wear layer over a cross-ply core |
| Movement with humidity | More | Less |
| Install methods | Nail down | Nail, or glue down (check the manufacturer) |
| Over concrete slab | Not recommended | Yes, glued down |
| Below grade (basements) | Not recommended | Yes |
| Refinishing | Many times over its life | Depends on wear layer: about 2 to 4 times |
Where engineered belongs
- On a concrete slab. Glue it down with a silane adhesive like Bona Quantum R851.
- Basements and other below-grade rooms, where solid boards would move too much.
- Wide planks. The cross-ply core keeps 5″ and 7″ boards flatter than solid of the same width.
- Where height matters, such as next to existing floors or under doors: a 3/8″ or 1/2″ board saves room.
Our unfinished engineered red and white oak is made in the USA from real American oak, in 3/8″, 1/2″ and 5/8″ builds and widths from 2-1/4″ strip to 7″ plank. Because it ships raw, you can stain it any color and finish it in any sheen. See the full lineup on our Engineered Flooring page.
Where solid belongs
- On wood subfloors above grade: first and second floors over plywood or OSB.
- When the floor has to last for generations. With 3/4″ of real wood, solid can be sanded and refinished again and again.
- When the client wants the real thing, with the solid sound and feel underfoot.
We carry solid Red Oak, White Oak, Southern Yellow Pine and Hard Maple from NOFMA-certified U.S. mills, in Select, #1 Common and #2 Common. Brazilian Cherry (Jatoba) is imported. See species and widths on our Solid Hardwood page.
The wear layer question
How many times an engineered floor can be refinished comes down to the wear layer. Our 5/8″ builds carry a 4mm oak wear layer, good for about three sandings (maybe a fourth if the work is a light buff and recoat). The 3/8″ and 1/2″ builds carry 2.5mm to 3.2mm, good for about two to three. Those are the manufacturers’ numbers, assuming a light first sand.
Quick answers
Can engineered hardwood be stained and refinished?
Yes. Unfinished engineered is sanded, stained and finished on site just like solid. How many times it can be refinished later depends on the wear layer.
Is engineered hardwood real wood?
Yes. The top layer is real oak, and the core is real wood plies. Ours is made in the USA from American red and white oak.
Which is better over radiant heat?
Engineered is usually the safer choice because it moves less, but always follow the flooring and heating manufacturers’ instructions.
Pick it up at any of our six stores
Great prices on everything we carry is why professionals have trusted First Atlanta Flooring for 17 years. We open by 7 AM on weekdays (Marietta at 6:30 AM) in Alpharetta, Lawrenceville, Marietta, Norcross, Suwanee and Winder. Call ahead and we’ll have it pulled and ready.

